CT Head and Body Dose Phantoms

Capintec 2015 Catalog 597Allows the user to calculate:

• Computed Tomography Dose Index (CTDI).
• Dose profile.

The CT Dose Phantoms were designed in accordance with the Food and Drug Administration's performance standard for diagnostic x-ray systems, which includes regulations specifically applicable to CT systems (21 CFR 1020.33).

These phantoms can be used with any CT system designed to image both head and body. They can separate dose information for each. When performing dose profile measurements, the dose phantoms allow the user to collect information for the maximum, minimum and mid-range value of the nominal tomographic section thickness.

This essential phantom consists of two parts: a body phantom and a head phantom. Both are made of solid acrylic, 15cm thick, with diameters of 32 cm and 16cm respectively. Each part contains five probe holes, one in the center and four around the perimeter, 90° apart and 1 cm from the edge. The inside diameter of the holes is 1.31 cm. Each part includes five acrylic rods for plugging all the holes in the phantom.

 

THE CTDI CAN BE MEASURED

• At the axis of rotation of the phantom
• Along a line parallel to the axis of rotation and 1.0 cm interior to the surface of the phantom
• For each selectable CT condition of operation that varies either the rate or duration of x-ray exposure
• At the location coincidence with the maximum CTDI at 1 cm interior to the surface of the dosimetry phantom for each selectable peak tube potential

 

MEETS FDA PERFORMANCE STANDARDS!

• Component Weights: Body Phantom, 32 lbs, head phantom, 8 lbs
• CT Head Dose Phantom, with Five Plugs
• CT Body Dose Phantom, with five Plugs
• Storage and Carrying Case (Only available if head and body are purchased)

 

ITEM NUMBERS

CT Head Dose Phantom.................................................................. 0695-0113

CT Body Dose Phantom .................................................................. 0695-0114